Volquartsen Exact Edge Extractor for MKI, MkII, Mk III, MK IV and 10/22

With the original Ruger Mark II extractor, I was experiencing about one FTE every magazine. Installed the Exact Edge extractor in about 5 minutes - very easy, DIY replacement (look for youtube video). So far, 250 rounds of cheap bulk ammo from four manufacturers with no malfunctions.

I bought this just in case and Sue enough my 1978 10/22 started stove piping. Swapped the extractor and fixed the issue immediately. Great that it works in mkiii or 10/22. I'm going to get another so I don't have total mission failure if another fails.

This extractor solved my extracting problem on my Ruger mark 1, have shot 500 rounds with no extraction problems.

Great product. Had many failures to extract with the old factory extractor. This pulls and throws empty shells with ease and vigor.

This extractor has been great. Really revitalized my Ruger MKI that had a rounded off edge. This extractor flings the shells way further. Please note if installing on MKI you will want to use the original spring on the bolt.

This part, included with the competition kit, worked for 4 months, and then snapped in half while at the range. Kind of annoying, even if it is a relatively inexpensive part. The extractor that came with the gun was cheaper (free) and didn't break after 4 months.